Journal of the Japan Society of Polymer Processing
CONTENTS FEBRUARY Vol.6 No.2 1994

Special Issue on Countermeasures against Molding Failure

Preface
A Role of Universities and Institutes in the Development of Countermeasures against Molding Failure: Isao Satoh, 71

Technical Notes
Defect of Crystalline Plastic Molds and Its Shooting: Isao Satoh / Yoshifumi Furuta / Junko Hashizume, 75
Nonuniform Quality of Crystalline Thermoplastic Moldings: Nobuhiko Nishiwaki / Sankei Hori / Masaaki Konno / Ailing Cui, 78
Countermeasures for the Defect of a Plastic Pipe Joint Based on the Quality-control Engineering: Naoki Murakami / Hiroshi Harada / Hiroyuki Moritani, 80
Improvements for Sink Mark and Warpage by Gas-assisted Injection: Shinji Kiboshi / Akimasa Kaneishi, 86
Molding Defects of Substrates for Optical Disc in Injection Molding and Those Countermeasures: Masaki Yoshii / Naotake Ebinuma, 90
Injection Molding Defect and Countermeasure of Optical Products: Toshio Yagi / Tetsuo Suga, 94
Understanding and Controlling the Generation Phenomena of Surface Defects on Molded Products: Hidetoshi Yokoi, 100

Technical Report
Introduction of "SP Series" for Profile Measurement: Akira Satoh, 104

Views on Processing Technique
Reviews on the Materials and Molding Technologies of Plastic Automotive Parts: Toshio Yokoi, 108

Special Lecture
Estimation, Measurement and Control of Heat Transfer Phenomena in Polymer Processing (9): Yasuo Kurosaki / Isao Satoh, 118

Original Papers
Reactive Processing of Polyamide and Polyester: Yasushi Watanabe / Tomokazu Inaba / Takehiko Kikuchi / Tomohiro Kuramochi / Masaru Ibonai, 125
Investigation of a Mold for Evaluating Injection Molding Techniques: Ceramics Molding Process: Yasuhiro Kimura / Jiro Matsuda / Masayoshi Koike, 135

Reports from Universities and Institution in Japan
Lecture on "MHT", Design and Production, Department of Mechanical Engineering, Kyushu Institute of Technology: Masahiko Fukui, 115

Title Service (1) 104