Journal of the Japan Society of Polymer Processing
CONTENTS Vol.9 No.11 1997

Special Issue on Sensing and Control of Molding Phenomena in Polymer Processing

Preface
An Expectation and Role of Measurement and Control Techniques in Polymer Processing: Oyanagi, Yasushi, 835

Technical Notes
Mold Temperature Control for Precise Transcription of Mold Surface with Fine Pattern or Mirror Plane in Injection Molding: Kato, Kazunori / Yasuhara, Toshiyuki, 836
Automated Switchover in Injection Molding by AI: Hirano, Tatsuo, 843
Technique of Instrumentation for Blow Molding: Koyama, Kiyohito, 848
The Method of Fiber Orientation Control in Injection Molding Process: Miyazaki, Hirotaka, 854
Measuring Technique Using Ultrasonic Waves: Nishiwaki, Nobuhiko / Hori, Sankei, 859
State of the Art On-line Rheometry with Melt Return: Goettfert, Axel / Sakata, Minoru, 865

Memoir
Japanese Plastics Machinery in 1950: Ohno, Ichiro, 870

Special Lecture
Trend of Polymer Processing Machines (11): Aoba, Takashi, 875

Re ports from Universities and Institutions in Japan
Engineering Design of Textile Products Laboratory, Dept. of Polym. Sci. & Eng., Faculty of Textile Science, Kyoto Institute of Technology: Tanaka, Katsufumi, 881

Reports of International Meeting
Reports of IUMRS-ICA-97: Takahara, Atsushi, 884

Reports from Oversea Universities and Institutions
The University of Manchester Institute of Science and Technology: Ito, Masaki, 886

Original Papers
Injection Molding of Synthetic Resin Using Heat Insulating Layer-coated Mold - Effect of Heat Insulation Layer Characteristics on Improvement of Surface Transferability of the Molded -: Kataoka, Hiroshi / Umei, Yuo / Kato, Iwao, 889
Measurement of the Crystallinity for PET Films by Complex Dielectric Constant Method: Nagata, Shinichi / Koyama, Kiyohito, 897
Three-dimensional Flow Visualization and Numerical Simulation of Polymer Solution through Abrupt Contraction: Wen, Hongzhao / Nakamura, Kiyoji, 904
Measurement of Three Dimensional Fiber Orientation Distribution in Fiber Reinforced Thermoplastics Using Scanning Acoustic Microscopy: Kawamura, Munehiro / Morita, Satoru / Tanaka, Minoru / Tachibana, Teruo, 913
Fabrication of Continuous Fiber-reinforced Thermoplastic Composites from Sheath-core Type Bicomponent Fibers: Furuta, Tatsuhiko / Radhakrishnan, A. / Ito, Hiroshi / Kikutani, Takeshi / Okui, Norimasa, 920

Q & A in Polymer Processing - Advices for a Better Molding Technology -, 927

Title Service (1) 847, (2) 858, (3) 864, (4) 874, (5) 883