Journal of the Japan Society of Polymer Processing
CONTENTS AUGUST Vol.8 No.8 1996

Special Issue on Recent Hybrid Molding Technology

Preface: Tadamoto Sakai, 503

Technical Notes
Multi-material Molding Using Thermoplastics Elastomers with Low Solidity: Noritaka Ogawa, 504
Low-pressure Molding and It's Application: Shohei Masui / Masato Matsumoto, 511
Direct Molding of Volume Reduced Waste Foam Plastics and It's Applications: Yoshikuni Yoshimitsu / Kiyoshi Marushita / Ichiro Shimohara, 518
Plastic Injection Molding with Rubber Bushing for Vibration-isolating Rubber: Seiji Onai, 524

Technical Reports
Development of In-mold Coating Process for Thermo plastics Injection Molding: Takeshi Fujishiro / Toshiaki Izumida / Kenji Yonemochi / Kenji Ohta, 530
Application of Co-injection Molding for Automotive Products: Hiroshi Mukai / Yasunobu Teramoto, 532

Views of Processing Technique
The Improvement of PP Based on the Structural Position: Hiroshi Awaya, 537

Original Paper
Examination of Reliability Evaluation Method of the Flow Analysis Simulation: Osamu Watanabe / Takashi Hasegawa / Tokio Kikuchi, 551

Reports from Universities and Institutions in Japan
Material Processing Engineering Laboratory, Department of Chemical Engineering, Kyoto University: Masataka Tanigaki / Masahiro Ohshima / Kenichi Kurumada, 544

Reports from Oversea Universities and Institutions
Massachusetts University: Hiroki Uehara, 548

Q&A in Polymer Processing - Advices for a Better Molding Technology -, 543

Title Service (1) 517, (2) 523, (3) 529, (4) 547, (5) 561
Information for Authors, 562