Journal of the Japan Society of Polymer Processing
CONTENTS MARCH Vol.8 No.3 1996

Technical Notes
Development of Simultaneous Composite Injection Molding Method to Two-layered Molding: Hiroyuki Hamada / Kiyotaka Tomari / Satoru Yamauchi, 145
Development of Super Precision Part on PPS: Toshimi Arashi, 151
Measurement of Fault in the Extruded Film: Touru Noda / Takuya Seri / Koh-hei Nitta, 157

Technical Report
In-Mold Labeled Bottle in Blow Molding: Toshifumi Tanabashi, 162

Views on Processing Technique
My Thoughts through the Development of Syndiotactic-polystyrene: Michitake Uoi, 167

Special Lecture
High Speed Flow Behavior of Molten Polymer in Processing (7): Kenji Iwakura / Hiraku Takeda / Kiyohito Koyama, 176

Original Papers
Dispersion of Calcium Carbonate Particle in Polypropylene Compound: Kazuta Mitsuishi / Michinori Kawano / Noriyuki Nagayama, 183
A Digital Detection of the Injection Speed by Using the Screw Position Encoder: Takayoshi Shioiri /
Kiyohito Yamasawa, 189
Optimization of Thickness Distribution of Products in Thermoforming Process by Computer Simulation:
Yoshinori Maekawa / Hideo Yanagi, 198

Reports from Universities and Institutions in Japan
Department of Materials Science and Engineering Shibaura Institute of Technology: Kunihiko Takeda, 172

Q&A in Polymer Processing - Advices for a Better Molding Technology -, 205

Title Service (1) 175, (2) 182