Journal of the Japan Society of Polymer Processing
CONTENTS SEPTEMBER Vol.7 No.9 1995

Special Issue on Melt Polymer Flow and Orientation
Preface: Sadao Arai, 531

Technical Note
Trend of Polymer Melt Flow and Fiber Orientation Analyses: Takaaki Matsuoka, 533

Technical Reports
Control Technique of Rubber Compound Orientation in Extrusion: Toru Sato, 537
The Effect on Warpage Prediction for Fiber Reinforced Material by Difference Consideration for Fiber Orientation: Yoshihiro Matsuura / Yoshihiro Nagata / Masahiro Fujii / Shinichi Hirayama, 541

Views on Processing Technique
Technology of Molding Tool for Home Electric Appliances: Yasuhisa Kawano, 549

Special Lecture
High Speed Flow Behavior of Molten Polymer in Processing (2): Kenji Iwakura / Hiraku Takeda / Kiyohito Koyama, 555

Original Papers
Flow of Polymer Melt in a Disk-shaped Mold under Ultrasound Radiation: Yorinobu Murata / Satoshi Kimura / Keiji Minagawa / Jun-ichi Takimoto / Kiyohito Koyama, 563
Mechanism of HDPE Thermal Expansion Coefficient Distributions under Extrusion Process: Kousuke Terada / Masashi Yamabe / Minoru Shimbo / Yasushi Miyano / Toshihisa Kajiwara / Kazumori Funatsu, 568
Elongation Flow and Crystallization Behavior in Supercooled Melt Polymer: Hirosh Ito / Takashi Kawamura / Jun-ichi Takimoto / Kiyohito Koyama, 576
The Relation between the Layered Structure and the Resin Behavior in Injection Molding Process: Mamoru Ishijima / Masashi Yamabe / Shinichi Nagata / Minoru Shimbo / Yasushi Miyano, 582
Orientation Distribution of Whiskers under Uniaxial Elongational Flow - Comparison with Jeffery Theory -: Masatoshi Kobayashi / Jun-ichi Takimoto / Kiyohito Koyama, 590
Novel Method of Observation of Flow Induced Fiber Orientation in Injection Molding: Tokio Kikuchi / Takashi Hasegawa / Osamu Watanabe, 595
Visual Analysis of Fiber Orientation Process by Glass-Inserted Mold Part I Analysis Based on Back-Lighting Method: Hidetoshi Yokoi / Yasuhiko Murata / Yoshio Nishi / Takekuni Seki, 600

Reports of International Meeting
SPE ANTEC '95: Yuji Higuchi, 562

Reports from Universities and Institutions of Japan
Division of Manufacturing Technology and Science, Department of Mechanical Engineering and Science, Tokyo Institute of Technology: Kazunori Kato, 549

Q&A in Polymer Processing - Advices for a Better Molding Technology -, 548