Journal of the Japan Society of Polymer Processing
CONTENTS MARCH Vol.7 No.3 1995

Special Issue on Development in the Molding Technology of Thin Wall Container and Pannell

Technical Notes
Container Production by Vacuum-thermoforming: Toru Takahashi, 139
Thin Wall Container Production by Injection Molding: Yoshiyuki Chousho, 146
Container Production by Injection-blow Molding: Nobukuni Ibe, 151
Thin Wall Container and Pannell by Blow Molding: Norio Shin, 157

Technical Report
Development of CFRP Turbocharger Impeller: Tomaru Ogawa / Koichi Handa / Tamaki Asakawa / Katsuyuki Yamamoto, 163

Views on Processing Technique
Present Status and Future Development on Plastic CAE: Kazurni Tada, 177

Special Lecture
Introduction to Composite Material Engineering (8): Zenichiro Maekawa, 182

Original Lecture
The Influence of Annealing on Fatigue Strength in Polyethylene: Koichi Kitano, 190

Reports from Universities and Institution in Japan
Department of Mechanical Engineering, Okayama University of Science: Toshiaki Kaneeda, 168

Reports from Oversea Universities and Institution
Georgia Institute of Technology: Wataru Seki, 174

Reports of International Meeting
PCR'94: Hiroyuki Hamada, 171
The Winter Annual Meeting of ASME: Yasuo Kurosaki, 172

Q&A In Polymer Processing - Advices for a Better Molding Technology -, 162

Title Service (1) 150, (2) 189