Journal of the Japan Society of Polymer Processing
CONTENTS SEPTEMBER Vol.6 No.9 1994

Special Issue on Look in the Principle of CAE

Technical Notes
Basic Equation for CAE in Polymer Processing, Kiyohito Koyama, 591
Review on Procedures of Numerical Analysis (What Does the CAE Software Do in a Computer?): Isao Satoh, 597
How to Getting the Material Database in Injection Molding Simulation Programs: Isao Tsujimura, 606
Simulation of Polymer Processing-Verification by Experiment-: Akio Horiguchi / Toshihiro Ueda / Norio Hayashi, 612

Technical Report
The Latest Technology of Plastic CAE: Norihiro Kambara, 619

Views on Processing Technique
Engineering of Plastics Design and Molding for Environmental Objectives: Tsuguo Kobayashi, 623

Technical Data
Study on Database of the Polymer Blends (1): Kihachi Nagaya / Toshihiko Ogawa, 629

Special Lecture
Introduction to Composite Material Engineering (3): Zenichiro Maekawa, 636

Original Papers
Study of the Fabricated Condition of UV-cured Resin: Kazuaki Shikichi / Nobuyuki Kondou / Yukinobu Yao / Youichi Kitamura / Masayoshi Horiuchi, 642
Strength Evaluation of Hybrid Composite Materials Using Minute Accumulating Method: Mitsumasa Higuchi / Shoichiro Shin / Hiroshi Yano, 649

Reports from Universities and Institution in Japan
Polymer Applied Physics Laboratory, Department of Applied Chemistry, Faculty of Engineers, Kansai University: Mitsukazu Ochi, 633

Title Service (1) 605, (2) 635, (3) 657