Journal of the Japan Society of Polymer Processing
CONTENTS JULY Vol.6 No.7 1994

Greeting From New JSPP President: Ikuo Narisawa, 449

Special Issue on Recent Progress of Polymer Processing―The Fifth "Aoki-Katashi" Award

Technical Notes
Development of CAE Systems Used for Plastic Packaging of LSI Devices: Junichi Saeki / Kazuhiro Sugino / Toshihiro Yasuhara / Kunihiko Nishi / Aizo Kaneda, 450
Super High Flow Rate Injection Molding Machine Controlled by Hydraulic-Software Servo System: Makoto Nakasawa / Nobuyuki Nakamura / Toshiyasu Kouda /Hidemi Aoki / Tsuyoshi Arai, 458
Full Automatic Production System of Compression Molding Manufacturing: Kazuyuki Ueda / Tadashi Igata / Takao Morimoto, 465

Technical Report
Behavior of Stamping Molding of the Long Fiber Reinforced Thermoplastics: Kazuyuki Obara / Yoshiyuki Tazuke, 473

Views on Processing Technique
Fundamentals of Injection Molding Engineering: Takashi Aoba, 480

Special Lecture
Introduction to Composite Material Engineering (1): Zenichiro Maekawa, 487

Original Papers
Optimization of Production System for Ceramic Injection Molding: Jiro Matsuda / Masayoshi Koike / Kenichi Tanaka, 496
A Study on the Strength of the Weld Region of an Injection Molded Article of Poly (oxy-2,6-dimethyl-1,4-phenylene) and Polyamide Alloy: Kunihiko Takeda / Junichi Nakahashi / Osamu Ishihara, 504
Rheological Properties and Mixed Structures of SEBS Block Copolymer/Polystyrene Blend System: Kenji lwakura / Masaki Mori / Takashi Abe / Fumio Suzuki, 511

Reports from Universities and Institutions in Japan
Laboratory of Engineering Materials, Department of Mechanical Systems Engineering, Faculty of Technology, Kanazawa University: Masashi Kitagawa / Takeshi Yoneyama / Hiroyuki Kagawa, 484

Review Process of Original Papers: Kazumori Funatsu, 518

Title Service (1) 464, (2) 472, (3) 486
Instruction for Authors, 520