Journal of the Japan Society of Polymer Processing
CONTENTS AUGUST Vol.5 No.8 1993

Fifth Annual Meeting
Reports
Reports from the Fifth Annual Meeting of JSPP, 495

Invited Lectures in the Fifth Annual Meeting of JSPP
Technical Note
Evolution of the Automotive Bumper: Kazuyoshi Takeuchi, 517

Technical Notes
Group Control System in Injection Molding Factory: Kenji Nakagawa, 522
An Overview of Thermoplastic Composite Technology (3): Tatsuki Matsuo, 528

Technical Report
Characteristics of Electro-conductive Resin Composite on Injection Molding: Masaaki Miyahara / Yasuhiko Takeuchi / Kazuo Anzai, 534

Views on Processing Technique
Anticipated Young Researchers' Contribution - Polymer Processing and Polymer Materials - : Masahiro Kakugo, 546
Special Lecture
Estimation, Measurement and Control of Heat Transfer Phenomena in Polymer Processing (4): Yasuo Kurosaki / Isao Satoh, 551

Original Paper
Theoretical Study on Performance of a Twin Screw Extruder I. Development of a Computer Simulation Method for Three Dimensional Flow Analysis and Evaluation of Various Leakage Flow Using This Method: Toshihisa Kajiwara / Yoshio Nakano / Shinichi Ninomiya / Kazumori Funatsu, 557

Reports of International Meeting
MOFFIS 93 International Symposium: Yoshiyuki Suetsugu, 540
SPE ANTEC '93: Minoru Shimbo, 542

Reports from Universities and Institutions in Japan
Organic Material Division, Industrial Research Institute of Nagano Prefecture: Tetsuo Nishimura, 544

Title Service (1) 533, (2) 543, (3) 568, (4) 569