Journal of the Japan Society of Polymer Processing
CONTENTS June Vol.5 No.6 1993

Technical Notes
Choice of Plastic Materials for Washing Machine's Parts: Koichi Yoshizaki, 351
Spinning Phenomena of Pressure-sensitive Adhesive at Peeling: Yoshiaki Urahama, 357
Multilayer Blow Molding for Plastic Fuel Tank: Koichi Iwamoto / Takeshi Sugie, 365
An Overview of Thermoplastic Composite Technology (2): Tatsuki Matsuo, 372

Technical Report
A Melt Bank Monitoring and Control System: Masayuki Yagi, 383

Views on Processing Technique
Processing of Weight Saved Structural Composites―Continuous Processing of Artificial Wood: Fumihiko Okagawa, 378

Special Lecture
Estimation, Measurement and Control of Heat Transfer Phenomena in Polymer Processing (2): Yasuo Kurosaki / Isao Satoh, 393

Original Papers
A Numerical Simulation of Welding Process with Electrofusion Joint: Kazumori Funatsu / Toshihisa Kajiwara / Yoshio Nakano / Yuuki Nagashima / Hiroyuki Nishimura, 402
Crystalline Orientation and Mechanical Properties with Biaxially Stretching of Ultrahigh Molecular Weight Polyethylene and Low Molecular Weight Polypropylene Blend Gel Film II. Analysis of Orientational Mechanism in Crystalline with Simultaneous Biaxially Stretching of Gel Press and Press Films: Yoshio Oomoto / Takahiro Niwa / Shigehiro Hashizume / Sadao Hibi, 412

Reports of International Meeting
2nd International Conference on "Deformation and Fracture of Composites": Tatsuki Matsuo, 400

Reports from Universities and Institutions in Japan
Department of Materials Science and Engineering, Nagoya Institute of Technology: Sadao Hibi, 390

Title Service (1) 356, (2) 371, (3) 377, (4) 399, (5) 420