Journal of the Japan Society of Polymer Processing
CONTENTS FEBRUARY Vol.5 No.2 1993

Special Issue on In-Process Measurement and Control Techniques for Polymer Processing

Preface
In-Process Measurement and Control for Plastic Molding Process: Nobuhiko Nishiwaki, 77

Technical Notes
Control System for High Speed Spinning Process: Yasuo Takahashi, 79
Temperature Measurement Techniques for Polymer Processing by Using Thermocouples: Hiromi Hayashi, 83
Process Measurement and Control by Using Ultrasonic Transducers: Naomi Fushimi, 87
Sensors/Transducers for Injection Molding Machines: Kouich Sakai / Satoshi Tomita, 92
Application of AI for Total Control in Polymer Processing: Yoshiharu Inaba, 97

Technical Reports
Development of Mold Rapid Heating/Cooling System and Its Applications: Hideo Tanaka / Hirofumi Tateyama / Atsuhiro Suzuki, 107

Special Lecture
Strength and Durability of Plastic Materials (10): Ikuo Narisawa / Takashi Kuriyama, 120

Views on Processing Technique
Recollections and Future Developments of the "Balallced Film": Takashi Ueshima / Toshio Taka, 102

Original Papers
Anisotropy of Linear Thermal Expansion Coefficient of a Disk Injection Molded from Reinforced PA66: Hiroyuki Kikuchi / Kiyohito Koyama, 129
Morphological Studies of Polycarbonate/Poly (ethylene telephthalate) Blends: Tatsuro Kitaura / Kohei Kugo / Jun Nishino, 134

Forum
Research Group on Tribo-Materials and Processing: Isamu Sekiguchi, 119

Reports of International Meeting
International Symposium on Polymer Alloy and Composites: Takashi Kuriyama, 114

Reports from Universities and Institution in Japan
Ishibashi Laboratory, Chair of Advanced Engineering, Department of Mechanical Engineering and Production Engineering, Faculty of Engineering Niigata University: Tatsuya Ishibashi, 116