Journal of the Japan Society of Polymer Processing
CONTENTS DECEMBER Vol.5 No.12 1993

Technical Notes
On-line Measurement Technique in Melt-spinning Process: Takeshi Kikutani, 831
Injection Molding Methods for Reduction of Molding Pressure: Mamoru Kimura, 839

Technical Reports
Epoxy Resin Toughening with Polycarbonate and Elastomer: Kazuko Nagura / Tomoji Takahashi / Tatsuya Osako, 844

Views on Processing Technique
Effect of Super High Flow Rate in Injection Molding: Nobuyuki Nakamura, 849

Special Lecture
Estimation, Measurement and Control of Heat Transfer Phenomena in Polymer Processing (7): Yasuo Kurosaki / Isao Satoh, 861

Original Papers
Observation of Solidified Resin Behavior in a Cavity by Ultrasonic Waves: Nobuhiko Nishiwaki / Ailing Cui / Masaaki Konno / Sankei Hori, 870
Adhesion Method of ABS Resin to Phosphor Bronze Plate Treated with Triazine Thiols by Insert-molding: Hideyuki Sasaki / Takatoshi Kohno / Takashi Komukai / Kohji Segawa / Ichiroh Kobayashi, 875
Structural Failure of a Plastic Part Injection-molded with a Metal Reinforcement: Hiroyuki Kikuchi / Kiyohito Koyama, 881

Reports of International Meeting
Impact and Dynamic Fracture of Polymers and Composites: Ikuo Narisawa, 854
PPS Tokyo'93: Kazuhisa Kubota, 856
JP93 Tokyo: Kiyotaka Tomari, 868

Reports from Universities and Institution in Japan
Department of Mechanical Engineering, Machine Design Engineering, Osaka City University - Studies on Mechanism of Large Deformation in Solid Polymers: Yukuo Nanzai, 858

Title Service (1) 838, (2) 848, (3) 855

Instruction for Authors, 890
Total Contents of Issues from Vol.5 No.1 to No.12 1993, 895