Journal of the Japan Society of Polymer Processing
CONTENTS OCTOBER Vol.3 No.8 1991

Special Issue on Surface Design and Mold Technology

Technical Note
Evaluation and Quantitative Treatment of Transferability: Hiroshi Yano / Takashi Kamoshita, 509
Transferability of Electroforming Machining and its Utilization: Yasuhiro Maki / Nobuyasu Yokochi, 517
Mold Technology to Realize High Quality Graining, The Precision Casting Mold: Hidetsugu Kato, 525
Etching Texture and Mold Transferability in Injection Molding: Hiroyuki Koike, 533

Special Lecture
Extrusion - Theory and Practice (6): Kanji Otani / Kazuyuki Nakamura, 544

Original Papers
Melt-Recrystallization of Talc-Filled Polypropylene Injection Moldings: Mitsuyoshi Fujiyama, 556
Adaptive Process Control in Injection Molding - Holding Pressure Control by the Filling Time Measurement - : Kazutoshi Yakemoto / Zenichiro Maekawa / Hiroyuki Hamada / Tadamoto Sakai, 567

Reports of International Meeting
Report on the ICCM/8: Hiroyuki Hamada, 540

Reports from Universities and Institutions in Japan
Industrial Technology Research Institute of Saitama Plastic Section: Hiroyuki Ishii, 541

Instruction for Authors, 580