Journal of the Japan Society of Polymer Processing
CONTENTS MAY Vol.3 No.3 1991

Special Issue on Large Parts for Automobile Used and Injection Molding Technology-II

Technical Note
The Fundamental Technology Supporting the Large Size Injection Molding Products (1):
Takeshi Ono / Michiyasu Kogishi / Hitoshi Nakasa, 177
The Fundamental Technology Supporting the Large Size Injection Molding Products (2):
Tatsushi Ishii / Masashi Yamabe, 184
The Fundamental Technology Supporting the Large Size Injection Molding Products (3):
Akihiko Koshiro /Koichi Odaka, 191

Special Lecture
Extrusion -Theory and Practice (1): Kanji Otani / Kazuyuki Nakamura, 202

Original Papers
Thickness Measurements of Two Layer Films by IR: Akitaka Senuma / Jun-ichi Hakozaki, 209
Structures and Properties of Injection-Molded Polypropylene Copolymers with Ethylene I. Structure- Property Relationships: Mitsuyoshi Fujiyama /Tetsuo Wakino, 217
Structures and Properties of Injection-Molded Polypropylene Copolymers with Ethylene II. Distribution of Higher-Order Structures: Mitsuyoshi Fujiyama / Tetsuo Wakino, 225

Reports of International Meeting
Report on the PPS-7: Tetsuo Uwaji, 201

Reports from Universities and Institutions in Japan
Outline of Plastic Division in Osaka Municipal-2 Technical Research Institute-Part2: Akinori Fukuda, 198

Instruction for Authors, 238