Journal of the Japan Society of Polymer Processing
CONTENTS APRIL Vol.3 No.2 1991

Special Issue on Large Parts for Automobile Used and Injection Molding Technology

Preface
Future Prospect of Large Size Injection Molded Parts: Reishi Tamura, 103

Technical Note
Molding Material - Engineering Plastic Alloy as Materials for Outer Panel: Etsuji Okumura / Taichi Nishio / Masahiro Kakugo, 106
Recent Developments and Molding Techniques of Polyolefine Bumper Materials: Susumu Iwanaga / Takashi Sugimoto / Yoshihiro Sobajima / Yoshinori Nishiya, 115
FMS Applications on the Large Injection Molding Machines and it's QMC System: Nagai Yasushi, 122
Multi Process Technology on Process Consolidation: Tadashi Suzuki, 128

Technical Reports
Injection Molding System for Hollow Parts: Shozo Nishida, 134

Special Lecture
A Fundamental Theory of Injection CAE Techniques and Its Applications-VII: Yasushi Oyanagi / Kazuhisa Kubota, 143

Original Papers
A Study on Processing Conditions of Thermoplastic Composites with Commingled Yarn (1st. Report: Commingled Effect on Bending Strength): Hiroyuki Hamada / Zen-ichiro Maekawa / Atsushi Yokoyama / Naoto Ikegawa / Tatsuki Matsuo / Masachika Yamane, 157
Study on Appearance of Injection Molded Plastics: Akihiro Wada / Shigetada Kawabata, 165

Reports from Universities and Institutions in Japan
Outline of Plastic Division in Osaka Municipal Technical Research Institute-Part I: Akinori Fukuda, 132

Instruction for Authors, 102