Journal of the Japan Society of Polymer Processing
CONTENTS Vol.10 No.7 1998

Special Issue on Research Reviews - Recent Developments and Directions of Polymer Processing -

Preface
Follower and Leader: Izawa, Shinichi, 457

Research Reviews
Injection Molding: Hori, Sankei, 458
Extrusion: Kajiwara, Toshihisa, 463
Blow Molding: Yamabe, Masashi, 469
Gas Assisted Molding: Tateyama, Hirofumi, 475
Fiber and Film Processing: Yamane, Hideki, 479
Polymer Composites: Fujita, Akihiro, 485
Polymer Alloys: Sanada, Takashi / Nishio, Taichi, 490
Mechanical Characteristics of Molded Polymers: Sekiguchi, Isamu, 494
Morphology and Structure Development in Polymer Processing: Fujiyama, Mitsuyoshi, 500
Rheoloical Properties of Polymer Melts: Isono, Yoshinobu, 507
Computer-Aided-Engineering: Yokoyama, Atsushi, 511
Measurements: Hashimoto, Toshimasa, 516
Recycle: Kimura, Teruo, 520

Views of Processing Technique
Plastic Injection Molding CAE-Its Development State of Art and Trend: Tanaka, Toyoki, 524

Reports from Universities and Institutions in Japan
Quality Control Systems Laboratory, Department of Management Systems Engineering, Faculty of Engineering, Kinki University: Gotoh, Masao, 531

Report from Oversea Universities and Institutions
Brunel University: Yasuda, Kazuharu, 535

Original Papers
Thermal Properties of Fiber-Filled Liquid Crystalline Polymers: Araki, Katsuhiko / Kitano, Takeshi / Ueyama, Akihiko / Unryu, Tsunemune, 539
Optimization of Runner Design Using Injection-Molding Flow Simulator - Control of Position of Weld-Line -: Yasutake, Kenji / Yokoyama, Atsushi / Hamada, Hiroyuki, 548
Control of Fiber Structure Using a Liquid Isothermal Bath in High-Speed Melt Spinning of Poly (vinylidene fluoride): Murata, Akira / Ito, Hiroshi / Kikutani, Takeshi / Okui, Norimasa, 554

Title Service (1) 462, (2) 499, (3) 515