Journal of the Japan Society of Polymer Processing
CONTENTS Vol.10 No.5 1998

Special Issue on Recent Development of CAE in Injection Molding and its Future

Preface
Comment on the Special Issue on Recent Development of CAE in Injection Molding and its Future: Funatsu, Kazumori, 291

Technical Notes
The Latest Information about Integrated Plastic CAE System: Mineta, Osamu, 292
Development of CAE System for Injection Molding: Tada, Kazumi, 298
On Understanding of Plastic CAE and its Operation: Kojima, Hirokazu, 302
3 Dimensional CAE System for Injection Molding: Sakaba, Katsuya / Nakano, Ryo / Tanaka, Toyoki, 311
Importance of Bench Mark in Current Plastic CAE: Koyama, Kiyohito, 319
Necessity for the Standardization of CAE Verification Bench Mark Tests: Kobayashi, Hiroyuki, 324

Technical Reports
Polymer Gel of Phase Separated 3-Dimensionally Network Structure: Mashita, Naruhiko, 329

Special Lecture
Trend of Polymer Processing Machines (17): Iwakura, Kenji, 334

Reports from Universities and Institutions in Japan
Division of Advanced Fibro-Science, Graduate School, Kyoto Institute of Technology: Maekawa, Zenichirou, 339

Reports of International Meeting
International Conference on Rubbers (Rubber'97): Yakemoto, Kazutoshi, 342

Reports from Oversea Universities and Institutions
University of Cambridge: Yonetake, Koichiro, 344

Original Papers
Analysis of Cure Behavior of SMC during Compression Molding: Hamada, Hiroyuki / Futamata, Keigo / Naito, Hajime, 348
Rheological Properties of Glass Fiber and Carbon Fiber Filled Liquid Crystalline Polymer Melts: Araki, Katsuhiko / Kitano, Takeshi / Ueyama, Akihiko / Unryu, Tsunemune, 357
Morphology and Properties of Weld Line in Injection Molded Polyacetal: Mizuno, Wataru / Tomari, Kiyotaka / Hamada, Hiroyuki, 365

Title Service (1) 328