Journal of the Japan Society of Polymer Processing
CONTENTS MAY Vol.6 No.5 1994
Special Issue on the Trends and Processing of Tanks and Pallets for Transportation, Large-sized Plastic Container and Drums
Technical Notes
Manufacturing Technology of Plastic Fuel Tank with High Fuel Permeation
Resistance: Katsuyuki Miura / Akira Hiraku / Teijiro Goto / Masato
Murakami, 287
The Processing and Trends of Plastic Pallets: Satoshi Matsubara
/ Tetsuya Fudaba / Naoto Sato / Kazuyuki Osone, 292
Processing of Plastic Drum: Eiichi Kodama / Yoshitaka Hirai, 297
Large Tanks' Limit Productivity and Development in the Future
by the Rotational Molding Method: Iwao Suzuki, 303
Plastic Containers-A Brief History and Future Growth Strategy:
Tadahiko Ichiki, 309
Present Status and Future Perspective of Flexible Containers:
Tatsuhiko Hirata, 315
Technical Report
AI Pressure Profile Trace Control on Fully Electric Injection
Molding Machine: Yoshiharu Inaba / Masao Kamiguchi / Noriaki Neko
/ Motohiro Nagaya / Kozo Inoue, 328
Views on Processing Technique
High Cycle Molding of Compact Disk: Seiya Sakai, 322
Special Lecture
Estimation, Measurement and Control of Heat Transfer Phenomena
in Polymer Processing (12): Yasuo Kurosaki / Isao Satoh, 335
Original Papers
A
Study on Simulation Method for Flow Analysis of Polymer Melts
in Dies-Applicable Range of an Approximate Analysis Method and
Three-dimensional Flow Analysis: Kazutaka Sakaki / Yoshifumi Kuwano
/ Toshihisa Kajiwara / Kazumori Funatsu, 342
Study
on the Influence of a Glass Cavity Wall on the Melt Flow Behavior
in a Glass-Inserted Visual Mold: Hidetoshi Yokoi / Yasuhiko Murata
/ Ichiro Sakamoto, 350
The
Relation between the Curing Conditions and Mechanical Properties
of Polyimide Resin: Shiro Nakazawa / Toshio Kunugi / Akihiro Suzuki,
356
Reports from Universities and Institution in
Japan
Fukushima Technology Centre: Osamu Watanabe, 326
Title Service (1) 291, (2) 321, (3) 363