Journal of the Japan Society of Polymer Processing
CONTENTS Vol.9 No.9 1997

Technical Notes
The Use of Injection Molding CAE for the Molding Material Development (2): Akiba, Toyohiko, 663
Extrusion-Blow Molding of PET Resin: Taniguchi, Shunro / Tai, Shinji, 667
Surface Treatment of Polymers: Naito, Kazuo / Kato, Nobuko / Saito, Shunji, 674
Properties and Applications of New Optical Resin: Wada, Yoshiharu / Ohtsuki, Toshihiro, 681
Microcellular Foaming Process: Ota, Toshimasa, 686
Polymer Processing Problems and Rheology: Nakajima, Nobuyuki, 693

Technical Data
Standards of Size Tolerance and Gear Accuracy for Molded Plastic Gears: Iwai, Minoru, 700

Technical Report
Biaxial Orientation of Ultra-High Molecular Weight Polymethyl Methacrylate by Press-Orientation Method: Kataoka, Hiroshi / Toyouchi, Kaoru / Ohkubo, Takeo / Kuriaki, Hiroshi, 713

Memoir
The Reminiscences of Plastic Molding Engineers, Part 5: Hiroe, Akitoshi, 719

Special Lecture
Trend of Polymer Processing Machines 9): Okamura, Hiroyuki, 724

Reports from Universities and Institutions in Japan
Kanamoto's Research Group, Department of Applied Chemistry, Faculty of Science, Science University of Tokyo: Kanamoto, Tetsuo. 733

Reports of International Meeting
Reports of SPE ANTEC'97: Hamamoto, Akio, 737

Original Papers
Applicapability of Differential Constitutive Equations for Steady Shear Flow, Elastic Recovery and Uniaxial Elongational Flow of High Density Polyethylene: Shinohara, Masayuki / Kajiwara Toshihisa / Funatsu, Kazumori, 739
Numerical Simulation of Correlation between the Configuration of a Channel and Solidification Process of Molten Polymer: Taniguchi, Masami / Aoki, Yoshiaki / Hirao, Yasuhiko / Aihara, Toshio, 750

Q & A in Polymer Processing - Advices for a Better Molding Technology -, 757

Title Service (1) 673, (2) 680, (3) 699, (4) 718, (5) 732, (6) 736