Journal of the Japan Society of Polymer Processing
CONTENTS Vol.9 No.10 1997
Special Issue on Technologies for Measurement, Discrimination and Control of Molding Defects
Technical Notes
Technologies of Molding Defects Discrimination and Measurement
for Control: Higashi, Keiji, 759
The Evaluation Method of Loging Data for Injection Molding: Hayasaki,
Hiroaki, 765
Relationship between Each Data in Injection Molding: Yamagiwa,
Yoshitoshi, 769
Pressure Profile Control and Quality Judgement of Molded Components:
Inaba, Yoshiharu / Kamiguchi, Masao / Neko, Noriaki / Watanabe,
Hiroshi, 776
New Technology on Machines and Control Systems for Quality Assurance:
Egi, Tadao / Yakemoto, Kazutoshi, 785
Technical Report
Reinforcement of Rubbers and Plastics by Organic Fibers: Sasakawa,
Eiichi, 795
Views of Processing Technique
Development of Plastics Industry in Toyama Prefecture: Watanabe
Nobuyasu, 799
Special Lecture
Trend of Polymer Processing Machines (10): Izawa, Shinichi / Nakamura,
Nobuyuki, 805
Reports from Universities and Institutions in
Japan
Nakagawa Laboratory, Institute of Industrial Science, University
of Tokyo: Nakagawa, Takeo, 810
Reports of International Meeting
Reports of PPS 13th: Saito, Takushi, 814
Original Papers
High
Weissenberg Number Problem and Numerical Simulation of an Annular
Extrudate Swell of Viscoelastic Fluids: Tanoue, Shuichi / Koga,
Jiro / Kajiwara, Toshihisa / Iemoto, Yoshiyuki / Funatsu, Kazumori,
817
Studies on the Slow-down Factors of Injection
Velocity during Thin Wall Molding Processes: Suganuma, Masashi
/ Saito, Yasunori / Nomura, Akio, 825
Title Service (1) 764, (2) 775, (3) 784, (4) 794, (5) 816