Journal of the Japan Society of Polymer Processing
CONTENTS JULY Vol.8 No.7 1996
Greeting from New JSPP President: Kazumori Funatsu, 419
Special Issue on JSPP International and Annual Conference '96
Reports from the International Conference
Plenary Lecture and Session I: Fracture and Strength of Moldings:
Ikuo Narisawa, 422
Session II: Extrusion: Tadamoto Sakai, 424
Session III: Injection Molding: Hidetoshi Yokoi, 426
Session IV: Durability of Moldings: Fujio Ohishi, 428
Reports from the Annual Conference, 430
Plenary Lectures in the International and Annual Conference '96
Technical Notes
The Present and Future of Engineering Plastics: Willem L.Sederel
/ Translated by Tadayuki Ishikawa, 442
Control of Internal Structure through Polymer Processing: Shinichi
Izawa, 446
Consumer Electronics Products and Injection Molding in the Globalization:
Takenori Ishii, 453
Reports on Selection of Society Award Winners: Takeo Nakagawa, 459
Reports on the Sixth JSPP Best Paper Award and
"Aoki-Katashi" Award
Technical Notes
Development of the Hollow Injection Molding System by the Die
Slide Method: Shozo Nishida / Tadao Egi / Atsuo Teraoka / Takashi
Uemura / Kunikazu Kazuta, 460
Development of Direct Injection Molding Process and Its Application
to High Performance Composites: Takeshi Moriwaki / Hiroki Nakajima
/ Kenji Tsutsui / Kenji Takahashi / Izumi Yamazaki, 467
Development of Recycled Gate Board Using Multi-Layer Extrusion
Molding Process: Junichi Kasai / Takuya Matsumoto / Fumio Otsuka
/ Iwao Kouno / Kazunobu Nakamori, 473
The Application of Blow Molding Simulation to the Plastic Fuel
Tank in the Development for the New Model Cars: Kousuke Terada
/ Ryuichi Matsuo / Toshiyuki Yariwake / Hiroki Isobe, 478
Resume of the Papers Receiving the JSPP Best
Paper Award
Visual Analysis of Fiber Orientation Process by Glass-Inserted
Mold: Yasuhiko Murata / Hidetoshi Yokoi / Motohiro Nagata / Hiroshi
Harada, 486
Elongational Flow and Crystallization Behavior in Supercooled
Melt Polymer: Hiroshi Ito / Takashi Kawamura / Jun-ichi Takimoto
/ Kiyohito Koyama, 486
Special Lecture
High Speed Flow Behavior of Molten Polymer in Processing (11):
Kenji Iwakura / Hiraku Takeda / Kiyohito Koyama, 487
Original Paper
Heat
Transfer Behavior in Solids Conveying Step of an Intermeshing
Twin Screw Extruder: Takehiko Motoda / Makoto Ishihara, 493
Title Service (1) 445, (2) 452