Journal of the Japan Society of Polymer Processing
CONTENTS JULY Vol.7 No.7 1995
Special Issue on Recent Progress of Polymer Processing - The Fifth "Aoki-Katashi" Award
Reports on Selection of Society Award Winners: Takeo Nakagawa, 406
Technical Notes
Development of Non-filler Phenolic Resin for Injection Molding:
High-purity "Amorphous Carbon" Grade: Masazo Takenaka
/ Kenichi Tanimoto / Mutsunori Yamao / Kenji Imao / Hidemi Ohhira,
406
Development of Injection-compression Molding Unit System: Tomokazu
Abe / Takayoshi Tanaka / Yoshiaki Saito / Satoshi Matsumoto /
Masanori Ohkubo, 411
AI Pressure Profile Trace Control in the Fully Electric Injection
Molding Machine: Yoshiharu Inaba / Yasushi Ishikawa / Susumu Ito
/ Masao Kamiguchi, 417
Resume of the Papers Receiving the JSPP Best
Paper Award
A Simulation of Crystallization in Injection Molding: Hiroshi
Ito / Yasuhiro Tsutsumi / Keiji Minagawa / Kazumi Tada / Kiyohito
Koyama, 424
Direct Observation of Blow Molding Process from Inside the Parison:
Shinji Imamura / Tsutomu Kaneta / Kousei Kushima / Akira Ohta
/ Toshio Herai / Kiyohito Koyama, 424
Technical Notes
Thermal Properties for Polymer Processing: Toshimasa Hashimoto
/ Junko Morikawa, 425
The Role of Rapid Prototyping in Polymer Processing: Takeo Nakagawa,
430
Technical Report
The Application of Infrared Melt Temperature Transducer to Injection
Molding: John Czazasty / Marcuz Hiyashi, 437
Views on Processing Technique
Plastic Products and Precision Injection Molding Process: Atsuhiro
Kitaide / Eiji Tai, 441
Special Lecture
Introduction to Composite Materials Engineering (12): Zenichiro
Maekawa, 453
Original Paper
Warpage
and Morphology of a Part Injection Molded from Polymer Alloy:
Hiroyuki Kikuchi / Kiyohito Koyama, 461
Reports of International Meeting
PPS-11 (Seoul): Toshihisa Kajiwara, 448
Reports from Universities and Institutions of
Japan
Mechanical Vibration, Mechanical System Engineering, Department
of Mechanical Engineering, Faculty of Engineering, Yamaguchi University:
Shunichi Kawano, 446
Reports from Oversea Universities and Institutions
IRC (Interdisciplinary Research Center in Polymer Science and
Technology): Norimasa Okui, 450
Q&A in Polymer Processing - Advices For a Better Molding Technology -, 460
Title Service (1) 410, (2) 436
Information for Authors, 468