Journal of the Japan Society of Polymer Processing
CONTENTS Vol.11 No.8 1999
Special Issue on 10th Annual Meeting
Report on 10th Annual Meeting of JSPP: Iwakura,
Kenji, 647
Report on the 10th Anniversary Ceremony of JSPP: Yokoi, Hidetoshi,
648
Congratulatory Greetings, 649
Reports on Presentation of Contribution to Society Awards and
Testimonials: Funatsu, Kazumori, 656
Reports from 10th Annual Meeting, 658
Technical Notes
The Growth and Future of the Plastic Industry of Japan - Review
Back to the Past Ten Years -: Nishizawa, Susumu, 670
Photonics Polymer for Multimedia: Koike, Yasuhiro / Tagaya, Akihiro
/ Ishigure, Takaaki, 680
Reports on Selection of Society Award Winners:
Funatsu, Kazumori, 685
Technical Notes
Re-melt Molding Technologies for Precise Plastic Optical Parts:
Koseko, Hisaaki / Hatakeyama, Toshiharu / Watanabe, Jun / Sawada,
Kivotaka / Hirano, Akio, 686
Paintless Technology by Material Coloring, and Sandwich Injection
Moiding: Mukai, Hiroshi / Kawashima, Daiichiro / Mizutani, Haruyasu
/ Koizumi, Junji / Manabe, Harutaka, 691
Application Development of (Molded Interconnects Device) by 2-shot
Molding Process: Yumoto, Tetsuo / Ohmura, Shingo / Aketa, Tomoyuki,
698
Resume of the Papers Receiving the JSPP Best
Paper Award
Louis Tredoux / Satoh, Isao / Kurosaki, Yasuo, 704
Motoda, Takehiko / Ishihara, Makoto, 704
Special Lecture
Application of Additives in Plastics Theory and Practice (10):
Tanaka, Mitsuaki, 705
Reports from Universities and Institutions in
Japan
The 4th Laboratory at Department of Applied Chemistry, Osaka Institute
of Technology: Nakamura, Yoshinobu, 710
Reports from Oversea Universities and Institutions
Polymeric Materials Research Institute, Shanghai Jiao Tong University:
Yin, Jie / Zhou, Chixing / Zhu, Zikang, 713
Original Papers
Evaluation
of P-v-T Properties of Crystalline Polymers Using Injection Molding
Processes Part II. Determination of P-v-T Properties in Molten
Phase: Kamata, Satoru / Kudo, Makoto / Moritoki, hitoshi / Koyama,
Kiyohito, 716
Estimation
of Coefficient of Thermal Expansion in the Thickness Direction
of Injection Moldings: Shimbo, Minoru / Ishijima, Mamoru / Yamabe,
Masashi / Miyano, Yasushi, 726