Journal of the Japan Society of Polymer Processing
CONTENTS Vol.10 No.2 1998
Special Issue on Multilayer Processing
Preface
Trend of Multi-layer Molding: Sakagami, Mamoru, 77
Technical Notes
High-speed Melt Spinning of Bicomponent Fibers: Kikutani, Takeshi
/ Radhakrishnan, J., 78
Multilayer Processing Technologies in Packaging Field: Katsura,
Tadahiko, 86
Lamellar Injection Molding: Barger, Mark A. / Kanai, Yasunori,
98
Multilayer Film Processing: Akatsu, Masamichi, 105
Multi-layer Injection Molding with Sandwich and its Derivative
Injection Molding: Kataoka, Hiroshi, 111
Special Lecture
Trend of Polymer Processing Machines (14): Murai, Rokuro, 119
Reports from Universities and Institutions in
Japan
Chemical Engineering Fundamentals, Department of Chemistry and
Chemical Engineering, Faculty of Engineering, Kanazawa University:
Yamada, Toshiro, 125
Original Papers
Fabrication
of Glass Fiber Reinforced Polypropylenes and their Physical Properties
1.Influence of Surface Treatment on the Mechanical Properties:
Nishitani, Yosuke / Sekiguchi, Isamu, / Nakamura, Ken-ichi / Nagatsuka,
Yoshihiro / Kitano, Takeshi, 129
Fabrication of Glass Fiber Reinforced Polypropylenes
and their Physical Properties 2.Influence of Surface Treatment
on the Rheological Properties in Molten State: Nishitani, Yosuke
/ Sekiguchi, Isamu / Nakamura, Ken-ichi / Nagatsuka, Yoshihiro
/ Kitano, Takeshi, 139
Q&A in Polymer Processing - Advices for a Better Molding Technology -, 149
Title Service (1) 104, (2) 128